how home auto circuit designed in proteus communicate with HASERVER
Discussion in "Project Doubts" started by asim amitav Feb 19, 2007.
Mon Feb 19 2007, 07:30 am
hello froends ,
i have designed the home automation project in proteus professional . then i i upload the sourcecode ha.c and debug then the com port is glowing . but my doubt is how to communicate with "haserver"Â should i have to change port no or any changes ???
2 . now is it nesessary to use relay circuit at the appliance section for viewing the status or only interfacing the led with uln2003A ic (which is connected with mc) .
 plz clarify the doubts clearly !!!
i have designed the home automation project in proteus professional . then i i upload the sourcecode ha.c and debug then the com port is glowing . but my doubt is how to communicate with "haserver"Â should i have to change port no or any changes ???
2 . now is it nesessary to use relay circuit at the appliance section for viewing the status or only interfacing the led with uln2003A ic (which is connected with mc) .
 plz clarify the doubts clearly !!!
Mon Feb 19 2007, 01:55 pm
Ans1: HAserver will not work with proteus!
Ans2: LEDs are helpful in debugging etc. so.. if you want you can keep them, otherwise you can connect ULN2003 directly to your controller and drive relay!
Ans2: LEDs are helpful in debugging etc. so.. if you want you can keep them, otherwise you can connect ULN2003 directly to your controller and drive relay!
Powered by e107 Forum System
DustinErele
Thu Apr 25 2024, 08:44 am
ztaletpzca
Wed Apr 24 2024, 11:19 pm
IrardlPex
Wed Apr 24 2024, 08:42 pm
Charlestehed
Wed Apr 24 2024, 05:20 pm
Robertgurse
Wed Apr 24 2024, 02:43 pm
Richardedils
Wed Apr 24 2024, 04:07 am
Malcolmaccek
Wed Apr 24 2024, 01:21 am
ChrisLub
Tue Apr 23 2024, 05:21 pm