Discussion in "8051 Discussion Forum" started by    rahuljin    Oct 11, 2007.
Sat Oct 13 2007, 03:03 AM
#11
my circuit board is based on 0-logic i.e. it works when 0 is passed to circuit board.

i mean that when circuit is on, circuit board pins has 1 to its pins and gives 0 to all the pins of the microcontroller. therefore when i give 0 value to the pins of the circuit board, circuit board give 1 to the microcontroller.
therefore when button is not pushed, 0 is passed to the pin of the circuit board and circuit board gives 1 to the pin of the microcontroller and microcontroller calls the interrupt.

circuit board is the test board which is very similar to ur (Ajay)
(sorry for so much trouble )


[ Edited Sat Oct 13 2007, 06:02 AM ]
Sat Oct 13 2007, 06:26 AM
#12
no there is nothing like trouble
so are you still having any problem?
Sat Oct 13 2007, 10:21 AM
#13
yes !!! interrupt is call without pushing the button !!!

and when the button is pushed, interrupt is not called.

but i want this in correct way !!! please guide me !!
Sat Oct 13 2007, 10:54 AM
#14
send me a good circuit.. so i can see what exactly you are doing.. ok
Sun Oct 14 2007, 12:39 PM
#15
all problems have been resolved !!! thanks Ajay for the great help and the best forum i hav seen !!!
Sun Oct 14 2007, 01:45 PM
#16
you're welcome we are always here for help

Get Social

Information

Powered by e107 Forum System

Conversation

No messages yet.

Downloads

Comments

Mirza123
Thu Jun 25 2020, 03:46 PM
eunicelove124
Mon Jun 22 2020, 03:03 PM
cerouno
Tue Jun 16 2020, 05:10 PM
Marce
Sat Jun 13 2020, 09:43 PM
Davidthils
Thu May 21 2020, 12:44 PM
Jakeror
Thu May 21 2020, 01:28 AM
motorCar
Wed May 20 2020, 07:05 PM
Vordrync
Wed May 20 2020, 11:52 AM

Online

Guests: 111, Members: 0 ...

most ever online: 182184
(Members: , Guests: 182184) on 06 Aug 2010: 05:37 AM

Members: 38215
Newest member: Mirza123