Electronic Voting Machine With manageable Control Unit (Project Report Included)

A project named "Electronic Voting Machine" has been submitted by following students:
Geetika Gupta, Vibhore Aggarwal, Megha Singh, Shivani.

Introduction:
EVM is capable of saving considerable printing stationery and transport of large volumes of electoral material. It is easy to transport, store, and maintain. It completely rules out the chance of invalid votes. Its use results in reduction of polling time, resulting in fewer problems in electoral preparations, law and order, candidates' expenditure, etc. and easy and accurate counting without any mischief at the counting centre. It is also eco friendly.

Our EVM consists mainly of two units - (a) Control Unit (CU) and (b) Ballot Unit (BU) with cable for connecting it with Control unit. Both the units consists of one microcontroller (8052) each. The CU consists of one LCD, one hex keypad and a couple of switches, while BU consists of a candidate panel, a votecast panel and a buzzer, etc.

This project is based on assembly language programming. The software platform used in this project are Keil uVision3 and SPIPGM37.

Thank you friends, for your contribution

Ajay

Tags electronics voting machine projectvoting machine project with report8051 project with report
printer friendly create pdf of this news item

Submit comment

(Required; Min length 5)
(Required; will not be displayed)

Downloads

Comments

Michailqfh
Fri Mar 29 2024, 01:53 am
Bobbyerilar
Thu Mar 28 2024, 08:08 am
pb58
Thu Mar 28 2024, 05:54 am
Clarazkafup
Thu Mar 28 2024, 02:24 am
Walterkic
Thu Mar 28 2024, 01:19 am
Davidusawn
Wed Mar 27 2024, 08:30 pm
Richardsop
Tue Mar 26 2024, 10:33 pm
Stevencog
Tue Mar 26 2024, 04:26 pm