Need help with Schematics

I am working on Smart parking project.
Here is my schematic.
I sent this to my professor and he said it is not right, i am not sure why. Also he said if i connect this to power source it will burn the source.
I am new at this so i really need help.
What am i doin wrong?

Take another look at the power supply to the LCD.
A reset button is handy for testing.
If the supply is no more than five volts, I don't see why the supply,
or anything else, would burn out.
I might have missed something.

Take another look at the power supply to the LCD.
A reset button is handy for testing.
If the supply is no more than five volts, I don't see why the supply,
or anything else, would burn out.
I might have missed something.

ExperimenterUK

It is about capacitor? i should put it between Vcc and gnd?
Dont understand what is wrong with reset.
Voltage source is 5V. Should i use voltage regulator?

It is about capacitor? i should put it between Vcc and gnd?

Yes.

I Dont understand what is wrong with reset.

There is nothing wrong with your reset.
It is just that you need to turn the power off to reset the circuit.
If you add a push button you can do a reset while leaving the power on.
Sometimes that is useful for testing and programming.

Voltage source is 5V. Should i use voltage regulator?

No a five volt supply is fine.
I was just looking for reasons why your professor might be was worried.
He might think your supply is more than five volts.